Icom IC-F210S - Table of Contents

ii
DO NOT use or place the transceiver in areas with tem-
peratures below –30°C or above +60°C, or in areas subject to
direct sunlight, such as the dashboard of a vehicle.
AVOID operating the transceiver without running the vehi-
cle’s engine. The vehicle’s battery will quickly run out if the
transceiver is in transmission while the vehicle’s engine OFF.
AVOID placing the transceiver in excessively dusty envi-
ronments.
AVOID placing the transceiver against walls. This will
obstruct heat dissipation.
AVOID the use of chemical agents such as benzine or
alcohol when cleaning, as they damage the transceiver sur-
faces.
BE CAREFUL! The transceiver will become hot when
operating continuously for long periods.
For U.S.A. only
CAUTION: Changes or modifications to this transceiver, not ex-
pressly approved by Icom Inc., could void your authority to operate
this transceiver under FCC regulations.
TABLE OF CONTENTS
IMPORTANT .................................................................................... i
EXPLICIT DEFINITIONS ................................................................. i
CAUTIONS ....................................................................................... i
TABLE OF CONTENTS .................................................................. ii
1 PANEL DESCRIPTION ........................................................... 1–5
■ Front panel ............................................................................... 1
■ Function LED ........................................................................... 2
■ Programmable function keys .................................................... 3
2 OPERATION ............................................................................ 6–8
■ Turning power ON .................................................................... 6
■ Channel selection ..................................................................... 6
■ Receiving and transmitting ....................................................... 7
D Transmitting notes ................................................................. 7
D Scrambler function ................................................................ 8
D User set mode ....................................................................... 8
3 CONNECTION AND MAINTENANCE .................................. 9–13
■ Rear panel and connection ...................................................... 9
■ Supplied Accessories ............................................................. 10
■ Mounting the transceiver ......................................................... 11
■ Optional UT-108 installation ................................................... 11
■ Optional UT-109/UT-110 installation ...................................... 12
■ Optional OPC-617 installation................................................. 12
■ Antenna................................................................................... 13
■ Fuse replacement .................................................................. 13
■ Cleaning ................................................................................. 13
4 OPTIONS ................................................................................... 14
IC-F110_210S_GEN-1.qxd 05.9.16 9:46 AM Page ii (1,1)