29
5
OPTIONAL SmarTrunk OPERATION
D PTT dispatch operation
*1
q Push [PTT] once (without dialling) to initiate a dispatch call.
w Begin talking after you hear three beeps (one short, high-
pitched, two very-short, low-pitched).
e Receiving a dispatch call is indicated by the same three-
beep sequence.
• It is not necessary to push [M] to answer a dispatch call.
D Placing a telephone call
*2
Enter the phone number followed by [1], [M].
• A high-pitched beep indicates that the number is accepted.
• When the called party answers, push the [PTT] switch to talk, and
release it to listen.
D Calling another local system subscriber
*2
Enter the subscriber number followed by [3], [M].
• A high-pitched beep indicates that the number is accepted.
• You hear ringing, then two short beeps when the subscriber
answers.
• If the other subscriber is on another call or out of range, you hear a
fast busy signal and the call terminates automatically.
D Memory speed-dialling
*2
To automatically dial a commonly used number from memory:
• Push [M] followed by the memory location (0–9).
D Emergency call
*2
Push [0], [M] to initiate an emergency call.
• Contact your dealer for details.
D Turbo SpeeDial
To automatically dial a commonly used number with one
push:
• Push one of the turbo SpeeDials ([A], [B], [C] or [D]).
D Programming memory speed dial
q Push and hold [M] until you hear a high-pitched beep.
w Enter the memory location (0–9, A, B, C, D), the telephone
or subscriber number, then [1], [M] (or [3], [M] if for another
system subscriber).
• A high-pitched beep indicates successful programming.
• Memories [A]–[D] are used for the Turbo SpeeDial.
D System busy indication
If all channels are busy, three low beeps sound after you initi-
ate a call. Try the call again later.
D Displaying the received ID record
(Available for SmarTrunk 3G™ only)
Push [Trunking Caller ID SW] to display the received ID
record in sequence.
• The latest received ID is displayed at first.
• The record is cleared when the transceiver is turned OFF.
*1
Available for 4-key version when the [M] or [#] key function is
assigned to any programmable key.
*2
Available for 10-keypad version only. Use the Turbo SpeeDial func-
tion instead.
NOTE: For additional operating instructions, contact your
Dealer.
IC-F34_44GT_GS-1.qxd 04.9.24 10:26 AM Page 29 (1,1)
To Next Page
Loading...
Need help?
General
