28
5
OPTIONAL SmarTrunk OPERATION
■ SmarTrunk II™,
SmarTrunk 3G™ and
conventional modes
This transceiver is capable of SmarTrunk II™/SmarTrunk
3G™ functions.
The optional UT-105/UT-117/UT-117S allow communications
in conventional channels, SmarTrunk II™/SmarTrunk 3G™
channels. Select a channel bank for SmarTrunk II™/
SmarTrunk 3G™ before trunking operation.
•Push [BANK] several times to select a channel bank for con-
ventional channels or SmarTrunk II™/SmarTrunk 3G™
channels.
- Scanning starts when a channel bank for SmarTrunk II™/
SmarTrunk 3G™ operation is selected.
- Contact your Dealer for channel bank details.
■ SmarTrunk II™ and
SmarTrunk 3G™ operation
These features are enabled by a Dealer and may not be
available in your system. Contact your Dealer for details.
D Receiving a call
*1
When you hear ringing, push [M] to answer.
• For a group call, you hear a short ring followed by two short beeps.
You do not have to answer a group call to hear it over the air.
D Terminating a call
*1
After completing a call, push [#] to disconnect (hang up).
IMPORTANT: If one person in the conversation terminates
a call, all participants will be cut off.
D Last number re-dial
*1
Push [M] 2times to automatically re-dial the last called num-
ber.
• A high-pitched beep indicates that the number is accepted.
D Clear channel alerting
*1
If all channels are busy, the transceiver automatically begins
searching for an open channel and beeps every ten seconds.
When two short beeps (low-pitched, then high-pitched) are
heard, a channel is available. Push [M], [M] immediately to re-
dial the last number.
IC-F34_44GT_GS-1.qxd 04.9.24 10:26 AM Page 28 (1,1)
To Next Page
Loading...
