14
5
RINGER FUNCTION (Analog mode operation only)
4
5
n Smart-Ring operation
The ring function has an answer back feature. This allows you
to confirm whether or not a call has reached to the member
of your group even if the operator is temporarily away from
the transceiver.
q Set the same operating channel and CTCSS tone code for
all of your group transceivers.
w Push
(S-Ring/Ringer) to send the Smart-Ring call.
• “
” and “
” appears.
• When a member of your group station answers your call, the
transceiver emits beep tones for every 10 sec. and “ ” blinks.
• Push [Side1] (MONI) to cancel the Ringer beep and “ ” blinks.
• When no answer comes back, the transceiver emits short failure
beep tones.
AppearsAppears
While transmitting
e Push [PTT] to answer the call and to stop the beeps and
blinking.
NOTE: This function is available only when the called
station has use the same CTCSS tone code and the
same operating channels as you.
(S-Ring/Ringer)
Pir
o Pir
o
Answer back (automatic)
Pi
ro
Pi
ro
Communication
Push
To Next Page
Loading...
Need help?
General
