Memory CH
: 1
Power(Hi) : 174
‘ ‘ ‘ ‘ ‘ ‘ ‘ ‘ ‘ ‘ ‘ – – – – – – – – –
Power(L2) : 88
‘ ‘ ‘ ‘ ‘ ‘ ‘ – – – – – – – – – – – – – –
Power(L1) : 44
‘ ‘ ‘ – – – – – – – – – – – – – – – – – – –
M O D N : 68
‘ ‘ ‘ ‘ ‘– – – – – – – – – – – – – – – – –
M O D W : 137
‘ ‘ ‘ ‘ ‘ ‘ ‘ ‘ ‘ ‘ ‘ – – – – – – – – –
DTCS N : 24
‘ ‘ – – – – – – – – – – – – – – – – – – – –
DTCS W : 51
‘ ‘ ‘ ‘– – – – – – – – – – – – – – – – – –
TXF SET :
BPF T1 : 40
‘ ‘ ‘ ‘ ‘ – – – – – – – – – – – – – – – – –
BPF T2 : - 9
‘ ‘ ‘ ‘ – – – – – – – – – – – – – – – – – –
BPF T3 : -17
‘ ‘ ‘ ‘ – – – – – – – – – – – – – – – – – –
BPF T4 : -15
‘ ‘ ‘ ‘ ‘– – – – – – – – – – – – – – – – –
AF Vol.L : 1
– – – – – – –– – – – – – – – – – – – – – – –
S Q L : 10
‘ ‘ – – – – – – – – – – – – – – – – – – – –
∗∗∗∗∗ Trimmer Control Software for IC–F300 Series ∗∗∗∗∗ Rev. 1.0
A/D VIN 165 : A5h 13.23V
A/D TEMPS 173: ADh 24.81'C
A/D LVIN 47 : 2Fh 0.92V
A/D SD 38 : 26h 0.75V
D/A DTCS BL 149 : 95h 58.43%
D/A SQL Lev 0 : 00h 0.00%
D/A BP T1 98: 62h 2.03V
D/A BP T2 49: 31h 1.41V
D/A BP T3 41: 29h 1.31V
D/A T4/POW 43 : 2Bh 1.34V
D/A REF 147: 93h 2.40V
D/A AF/Dev 0: 00h 0.00%
RX:440.20000MHz TX:440.10000MHz
MODE: Wide
POW: High
[Space]: A/D, D/A Read
[TAB]: Display Parameters [F8] at BPF: Sweep [F9] at BPF T1: Sweep T1
~
T4
[Enter] at TXF: REF Set Mode ↑ / ↓: Cursor Up/Down < / > : –/+ ESC : Quit
PLL lock voltage
Internal temperature
Operating channel
RF output power
FM deviation
Receive sensitivity
Reference frequency
Connected DC voltage
SQL level
DTCS balance level
Volume
Squelch
DTCS balance
The above values for settings are examples only. Each transceiver has its
own specific values for each setting.
NOTE:
To Next Page
Loading...
