Need help?Do you have a question about the Icom IC-F4GS and is the answer not in the manual?
General| Frequency Range | 400-470 MHz |
|---|---|
| Number of Channels | 16 |
| Power Output | 5W |
| Power Supply Requirement | 7.2 V DC |
| Mode | FM |
| Voltage | 7.2 V |
| Type | Transceiver |
Defines terms like DANGER!, WARNING!, CAUTION, and NOTE for user safety.
Details the physical components and their locations on the transceiver.
Explains the indicators and symbols shown on the transceiver's display.
Instructions for attaching supplied accessories like antennas and belt clips.
Step-by-step guide on how to safely remove and install battery packs.
Important safety warnings and handling instructions for battery packs.
Procedures for charging battery packs using different Icom chargers.
Guidelines and warnings for safe and effective battery charging.
Instructions for using the optional battery case with AA batteries.
Introduces programmable functions and how their activation depends on programming.
Describes how to lock and unlock the transceiver's keypad to prevent accidental operation.
Explains how to quickly select a pre-programmed priority channel.
Details how to use the scan function to search for signals on programmed channels.
How to switch between high and low transmit power levels for a channel.
Information on enabling voice security features using optional units.
How to enable or disable audible beep tones for key presses.
Explains how to check channel activity using monitor modes.
Describes the function to switch between duplex and simplex communication modes.
How to send DTMF codes for control or communication.
Function to re-transmit the last used DTMF code.
How to send an emergency signal to a base station quickly.
Options for controlling the backlight of the function display.
Basic procedures for receiving signals and transmitting voice.
Steps for making selective calls using tone signaling systems.
How to select a specific Tx code channel for selective calling.
Instructions for manually sending 5-tone codes.
Important information regarding time-out and penalty timers during transmission.
Explains DTMF pager and code squelch functions using optional units.
Guide on installing optional units into the transceiver.
Procedure for transferring data between transceivers.
Instructions for cloning transceiver data using PC software.
To Next Page
