■ General
In the following explanations, programmable function names are
bracketed, the specific switch used to activate the function depends
on programming.
D KEYPAD LOCK FUNCTION
This function locks access to all programmable switches (except
the switch assigned for the lock function).
Push and hold the [LOCK] switch for 1 sec. to toggle the lock func-
tion ON and OFF.
• “
”appears while the lock function is ON.
• This function may be inhibited on some channels.
D PRIORITY CHANNEL
This function is used to select a pre-programmed channel at the
push of a switch.
Push the [PRIORITY] switch to select the priority channel.
• “PRIO” appears briefly, then the priority channel is automatically se-
lected.
D SCAN FUNCTION
The scan function allows you to search a pre-programmed group of
channels for signals.
Push the [SCAN] switch to start/stop scan.
• Scan pauses on a channel when receiving a signal.
• Depending on programming, a message may appear while scanning.
• “Lockout SCAN” (pre-programmed list SCAN) or “Priority SCAN” can
be pre-programmed.
• When the “Power-save function” is activated, the transceiver checks
all pre-programmed channels then returns to the “Power-save func-
tion” again.
11
4
PROGRAMMABLE FUNCTIONS
To Next Page
Loading...
Need help?
General
