9
BIIS 1200 SYSTEM OPERATION
9-7
Transmitting a call
D Transmitting an Emergency call
When a BIIS channel is used as the Emergency
channel, a BIIS Emergency call can be transmitted
in the same way as in 2-Tone, 5-Tone, or NXDN
TM
signaling� See “Emergency call” for details� (pp� 4-3 ~
4-6)
If your transceiver is congured for Silent operation,
you can transmit Emergency calls without the beep
sounding or the display changing�
The transceiver can also be set to keep the
microphone open in the Emergency mode to monitor
the situation, depending on the presetting�
D Transmitting Position data
When the GPS function is ON, and the optional
HM-233GP gps speaker microphone receives
Position data, the longitude and latitude data can be
automatically transmitted:
• After sending a voice message�
L Set Send with Logoff to “Enable�”
• After sending a Status Message�
L Set Send with Status Call to “Enable�”
• After sending a Message�
L Set Send with Message Call to “Enable�”
• After sending an Emergency call�
L Set Send with Emergency to “Enable�”
NOTE: The settings above are required using the
CS-F52D programming software.
(GPS > BIIS)
To Next Page
Loading...
Need help?
General
