22
4
BIIS OPERATION
DD
Direct code entry
q While in the standby condition, push [P3] (TX Code Enter)
to enter the TX code edit mode.
• Code digit for editing blinks.
w Push [P3] (TX Code Enter) to select the desired digit to be
edited.
• Digit for editing differs according to the setting.
e Set the desired digit using [CH Up]/[CH Down] or 10-key-
pad*.
*IC-F70DT/T or IC-F80DT/T only
r Push [P3] (TX Code Enter) to set the digit, then the digit
to the right will blink automatically.
• When the 10-keypad is used for setting, the digit to the right will
blink automatically without pushing [P3] (TX Code Enter).
t Repeat e and r to input all allowable digits.
y Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and
“WAIT” is displayed during each call. However, an
error beep sounds and
“FAILED” is displayed when no
answer back is received after the calls.
u Push [PTT] to transmit; release to receive.
i Push [P4] (Moni(Audi)) to send the ‘Clear down’ signal.
For your information
When the “UpDate” setting for the call code is enabled, the
set code is overwritten into the call code memory.
To Next Page
Loading...
Need help?
General
