To Next Page

To Previous Page

BIIS OPERATION

■ Transmitting a call

A total of 3 ways for code selection are available—selecting

the call code from memory, entering the call code from the

keypad and calling back from the queue channel record.

Using call memory

q While in the standby condition, push [P1] (Digital) to enter

the call code memory channel selection mode.

•“ ” appears.

w Push [Up] or [Down] to select the desired call code.

e Push [P0] (Call) or [PTT]* to call.

*PTT call can be made only when PTT call capability is permitted.

NOTE: When no answer back is received, the trans-

ceiver repeats the call 3 times (default) automatically,

and

“WAIT” is displayed during each call. However, an

error beep sounds and

“FAILED” is displayed when no

answer back is received after the calls.

r Push [PTT] to transmit; release to receive.

t Push [P4] (Moni(Audi)) to send the ‘Clear down’ signal.

Calling back from the queue channel

q While in the standby condition, push and hold [P1] (Digital)

for 1 sec. to enter the queue memory channel selection

mode.

w Push [Up] or [Down] to select the desired record.