Icom ic-m423g - Softkey Function

7
2
PANEL DESCRIPTION
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
!6 POSITION INDICATOR
➥ Shows the current position when position data is re-
ceived, or the position is manually entered.
  •WhentheGPSpositionisinvalid,“??”mayblinkevery2sec-
onds instead of position. The last position is held for only
23.5 hours, and after that, “NO POSITION” is displayed.
  • “??”willblinkevery2secondsinsteadofposition,after4hours
have passed from the time when the position is manually en-
tered. The manually entered position is held for only 23.5 hours,
and after that, “NO POSITION” is displayed.
➥ “NO POSITION” is displayed when no GPS receiver is
connected, and no position is manually input.
!7 SCAN INDICATOR
“SCAN 16” is displayed during a Priority scan; “SCAN” ➥
is displayed during a Normal scan. (p. 20)
“DUAL 16” is displayed during Dualwatch; “TRI 16” is ➥
displayed during Tri-watch. (p. 20)
!8 LOCAL ICON* (p. 14)
Displayed when the Attenuator function is turned ON.
*For only U.S.A. and Australian version transceivers.
■ Softkey function
Various functions can be assigned to the softkeys. When a
key function is assigned, the key icon is displayed above the
softkey, as shown below.
Softkey function selection D
When “Ω” or “≈” is displayed beside the key icon, sequentially
pushing [Ω]/[≈] displays the previous or the next key function
that is assigned to the softkey.
Push Push
*
*Push this key to start
and stop scan.
The order of the key icons may differ, depending on the
presetting.