Icom ic-m423g - Radio Settings Customization

64
7
DSC OPERATION
■ DSC Settings (Continued)
D Channel 16 Switch function
By regulation, after receiving a Distress call, the transceiv-
er changes the operating channel to Channel 16. However,
when this setting is set to “OFF,” the function enables the
transceiver to remain on the operating channel, even after
receiving a Distress call.
q Enter “CH 16 SWITCH”
in the DSC Settings menu .
MENU ➪ DSC Settings ➪ CH 16 Switch
(Push [MENU].) (Rotate Dial, then push [ENT].)
w Rotate Dial or push [Y]/[Z] to set the Channel 16 Switch
function to “Auto (No Delay),” “10 Second Delay,” or “OFF,”
then push [ENT].
 •Push[BACK]toreturntothepreviousscreen.
(default)
Auto (No Delay): After receiving a Distress call, and
[ACPT] is pushed on the confirmation
screen, the transceiver immediately
changes to Channel 16.
10 Second Delay: After receiving a Distress call, and
[ACPT] is pushed on the confirmation
screen, the transceiver remains on the
current operating channel for 10 sec-
onds. After that, the transceiver auto-
matically changes to Channel 16.
(default)
OFF : Even after receiving a Distress call, the
transceiver remains on the operating
channel.
•“ ” is displayed.
Push [EXIT] to return to the normal operating mode. e