To Next PageTo Next Page
Need help?Do you have a question about the Icom IC-M802 and is the answer not in the manual?
General| Output Power (SSB) | 150W PEP |
|---|---|
| Output Power (AM) | 40W |
| Antenna Impedance | 50 Ω |
| Operating Temperature | -15°C to +55°C |
| Type | MF/HF Marine Transceiver |
| Frequency Range (Receive) | 0.5-29.999 MHz |
| Modes | SSB, AM, FM |
| Power Supply Requirement | 13.8 V DC |
| Current Drain (Transmit) | 30 A |
| Current Drain (Receive) | 1.5 A |
| Tuning Steps | 10 Hz |
| Receiver Sensitivity (SSB) | 0.5 μV (for 12 dB SINAD) |
| Waterproof | IPX7 |
| Frequency Range (Transmit) | 1.6 to 30 MHz |
Adjustment procedure for drive FETs idling current, including conditions and measurements.
Adjustment procedure for SWR detector, including conditions, measurements, and values.
Diagram showing component layout on the main unit's top side.
Diagram showing component layout on the main unit's bottom side.
Diagram showing component layout on the PLL unit's top side.
Diagram showing component layout on the PLL unit's bottom side.
Diagram showing component layout on the PA unit's top side.
Voltage distribution diagram for the main unit, section 1-1.
Voltage distribution diagram for the PLL unit, section 1.
Voltage distribution diagram for the PLL unit, section 2.
Voltage distribution diagram for the PA unit.
Voltage distribution diagram for the FILTER unit.
