Icom IC-SAT100 - Audio and Information Settings

MENU SCREEN
14
7
D Beep/Vibration
Sets the transceiver’s beep level and select an option
for vibration.
TIP: When you set the beep level to between
“1 (Linked)” and “5 (Linked),” you can adjust the
beep level within the range of 0 and selected level by
rotating [VOL].
System Beep Lv
Sets the system beep output level.
The beep sounds when connecting to or blocked from
the system.
Emer Beep Lv
Sets the beep output level when in the Emergency
mode.
Key Beep Lv
Sets the key beep output level.
Ringer Lv
Sets the ringer output level.
Opening Beep Lv
Sets the opening beep output level.
The transceiver beeps when it is turned ON.
System Vibration
Turn the system vibration ON or OFF.
The transceiver vibrates when connecting to or
blocked from the system.
Emer Vibration
Turn the Emergency vibration ON or OFF.
The transceiver vibrates when received an Emergency
call.
Key Vibration
Turn the key vibration ON or OFF.
The transceiver vibrates when you pushed any key
except [PTT].
Receive Vibration
Turn the receive vibration ON or OFF.
The transceiver vibrates when received any call or
message.
Opening Vibration
Turn the opening vibration ON or OFF.
The transceiver vibrates when it is turned ON.
D Information
Battery Info
Displays the battery information such as voltage,
battery percentage, cycle count, and so on.
RSSI
Displays the Received Signal Strength Indication
(RSSI).
My Position
Displays your current position.
Firmware Info
Displays the transceiver’s rmware information.
Satellite Info
Displays satellite information.
Certication
Displays the certications acquired with the
transceiver.
Menu items