9
2
BASIC OPERATION
Receiving and transmitting
Turning ON the transceiver
Hold down [VOL] for 1 second to turn
ON the transceiver.
• The transceiver searches a satellite.
• When the transceiver connected and
registered to the satellite, the status
name is displayed.
Push [Last Call] to playback the
received call.
(See the IC-SAT100M OPERATING
MANUAL for Last Call Play function
details.)
Push [UP] or [DOWN] to display the
Talkgroup List.
Rotate Talkgroup selector to select a
talkgroup.
Receiving
source transceiver’s name are displayed,
and audio should be heard.
Rotate [VOL] to adjust the audio output level.
Last Call
Ignore
LISTENING
TRANSCEIVER2
TALKGROUP01
Transmitting
CAUTION: DO NOT transmit without an
antenna.
1. Hold down [PTT].
transceiver requests the transmission.
2.
at your normal voice level.
You can continuously transmit up to the
period of time allowed by the system.
Last Call
Scan
TALKING
TRANSCEIVER1
TALKGROUP01
NOTE:
• If the connection becomes poor while
transmitting, the transceiver sounds the
• You cannot transmit while listening to
the received audio. Before transmitting,
Scan and Ignore
[Scan]
Push to scan a call.
[Ignore]
Push to ignore the received call.
The Ignore function will be canceled if there
are no more calls for 90 seconds or more.
NOTE: The transceiver receives and
transmits using several satellites orbiting
the same orbit. Receiving and transmitting
may fail depending on the satellite position
or any obstacles between the transceiver
and satellites.
Receiving and transmitting may fail,
depending on the satellite positions or
nearby obstacles.
8°
To Next Page
Loading...
Need help?
General
