How to fix frequency setting issues on Icom ID-1?
If the frequency cannot be set on your Icom Transceiver, the frequency lock function might be activated; turn the function OFF. Alternatively, priority watch might be paused on the watching frequency; cancel the watch.
What to do if the antenna feedline or connector has a poor contact in my Icom ID-1?
If the antenna feedline or the antenna connector of your Icom Transceiver has a poor contact or is short-circuited, check it. If necessary, replace the feedline or re-solder the antenna connector.
What to do if the Ethernet cable has a poor connection with my Icom ID-1 Transceiver?
If the Ethernet cable has a poor connection on your Icom Transceiver, try re-connecting the Ethernet cable. If that doesn't work, replace the Ethernet cable.
How to deactivate the squelch attenuator function on my Icom Transceiver?
If the squelch attenuator function is activated on your Icom Transceiver, set the squelch between the 10–12 o’clock position (application) or level 12 to 19 (RC-24).
What to do if another station is using tone squelch with my Icom ID-1?
If the other station is using tone squelch and you are having trouble with your Icom Transceiver, turn the tone squelch function ON.
What to do if priority watch is paused on the watching frequency on my Icom ID-1?
If the priority watch is paused on the watching frequency on your Icom Transceiver, cancel the watch.
What to do if my Icom ID-1 Transceiver does not turn on?
If your Icom Transceiver does not turn on, there might be several reasons. First, check the power connector pins for poor contact. Then, ensure the power cable is connected with the correct polarity. Finally, inspect the fuse and replace it if it's damaged. If the fuse is damaged, check the cause before replacing it.
Why is there no sound coming from the Icom Transceiver speaker?
If no sound is coming from the speaker of your Icom Transceiver, first, ensure that the volume isn't set too low and adjust it to a suitable level. Also, check the squelch level, as it might be set too high; adjust it to the threshold. Finally, verify that selective call or squelch functions, like pocket beep or tone squelch, are turned OFF.
How to improve the Icom ID-1 Transceiver sensitivity if only strong signals are audible?
If the sensitivity of your Icom Transceiver is low, and only strong signals are audible, the antenna feedline or connector may have poor contact or be short-circuited. Check the feedline and, if necessary, replace it or resolder the antenna connector. Also, the squelch attenuator function might be activated. Adjust the squelch between the 10–12 o’clock position or level 12 to 19, depending on your device.
Why does scan not operate on my Icom Transceiver?
If the scan function does not operate on your Icom Transceiver, ensure the squelch is set to the threshold point, not open. Also, program more memory channels, or cancel the memory skip function in the desired channels. Finally, cancel priority watch, if it is activated.
General| Brand | Icom |
|---|---|
| Model | ID-1 |
| Category | Transceiver |
| Language | English |
To Next Page
