Icom ID-1 Service Manual

■
GENERAL
• Frequency coverage : 1240.000–1300.000 MHz
• Type of emission : FM, GMSK (Digital)
• Transmission speed (theoretical value) : Data 128 kbps
Digital voice 4.8 kbps
• Codec : AMBE (2.4 kbps)
• Number of memory channel : 105 (incl. 2 scan edges and 3 calls)
• Tuning steps : 5, 6.25, 10, 12.5, 20, 25, 50, 100 kHz
• Frequency stability :
±
2.5 ppm (–10˚C to +60˚C)
• Operating temperature range : –10˚C to +60˚C (–22˚F to +140˚F)
• Antenna connector : Type-N (50
Ω)
• Power supply requirement : 13.8 V DC
±
15% (Negative ground)
• Current drain (at 13.8 V DC) : Transmit Less than 7 A (at 10 W)
Receive Less than 1.5 A (AF max.)
• Dimensions (projections not included) :
Main unit 141(W)×40(H)×165.8(D) mm; 5
9
⁄
16
(W)×1
9
⁄
16
(H)×6
17
⁄
32
(D) in
Remote controller (RC-24) 150(W)×50(H)×49.5(D) mm; 5
29
⁄
32
(W)×1
31
⁄
32
(H)×6
15
⁄
16
(D) in
• Weight (Approx.) :
Main unit 1.2 kg; 2 lb 10 oz
Remote controller (RC-24) 220 g; 7.7 oz
■
TRANSMITTER
• Output power (at 13.8 V DC) : 10/1 W
• Modulation : Variable reactance frequency modulation (FM)
Quadrature modulation (Digital)
• Maximum frequency deviation (FM) : ±5.0 kHz
• Spurious emissions : Less than –50 dB
• Microphone connector : 8-pin modular jack (600
Ω)
■
RECEIVER
• Receive system : Triple conversion superheterodyne system (FM, DV)
Double conversion superheterodyne (DD)
• Intermediate frequencies : 1st IF: 243.95 MHz, 2nd IF: 31.05 kHz, 3rd IF: 450 kHz (FM, DV)
1st IF: 243.95 MHz, 2nd IF: 10.7 MHz (DD)
• Sensitivity : Less than 0.18 µV (–122 dBm) at 12 dB SINAD (FM)
Less than 0.35 µV (–116 dBm) at BER 1×10
–2
(DV)
Less than 1.58 µV (–103 dBm) at BER 1×10
–2
(DD)
• Selectivity (typical) : More than 12 kHz/6dB, Less than 30 kHz/60 dB (FM)
More than 6 kHz/6dB, Less than 18 kHz/50 dB (DV)
More than 140 kHz/6dB, Less than 520 kHz/40 dB (DD)
• Spurious and image rejection : More than 50 dB
• Audio output power (at 13.8 V DC) : 2.0 W at 10% distortion with an 8
Ω
load
• Squelch sensitivity (at threshold) : Less than 0.18 µV (–122 dBm) (FM only)
• Ext. speaker connector : 2-conductor 3.5 (d) mm/(
1
⁄
8
")/8
Ω
All stated specifi cations are subject to change without notice or obligation.
S
SECTION 1 SPECIFICATIONS
1 - 1

Icom ID-1 Specifications

General

Brand	Icom
Model	ID-1
Category	Transceiver
Language	English