Icom ID-51E

5 - 9
5-3 TRANSMIT ADJUSTMENT (Continued)
• DEVIATION ADJUSTMENTS (Continued)
Select an adjustment item using
/
, and then set the adjustment value as specifi ed using [DIAL].
ADJUSTMENT
ADJUSTMENT
ITEM
OPERATION VALUE
DV BALANCE
–
1 1) Set the power supply voltage to 7.4 V.
2) Connect a modulation analyzer to the antenna connector through
an attenuator, and then set it as;
HPF : OFF
LPF : 20 kHz
De-emphasis : OFF
Detector : (P-P)/2
3) No audio signal is applied.
–
-VHF-
[BAND LOW]
[DVR]
2• While transmitting, adjust the deviation using [DIAL], and then
push
to store the adjustment value.
Minimum
deviation
[BAND CENTER]
3
[BAND HIGH]
4
-UHF-
[BAND LOW]
5
[BAND CENTER]
6
[BAND HIGH]
7