Icom ID-52A User Manual (English)

Other manuals for Icom ID-52A

Manual88 pages

Advanced Manual263 pages

Basic Manual88 pages

Questions and Answers:

M
Michael BookerJul 28, 2025
Why no sound from my Icom ID-52A Transceiver speaker?
- A
  Amber SolomonJul 28, 2025
  If no sound is coming from the speaker of your Icom Transceiver, there could be several reasons: * The volume may be too low. Rotate [VOL] to adjust the level. * The squelch level might be too high. Try adjusting the squelch level. * The tone or digital squelch function could be turned ON. Turn OFF the tone or digital squelch function. * An external speaker may be connected to the [SP] jack. Check the external speaker connection. * A Bluetooth headset might be connected. Disconnect the headset.
J
Jennifer BowenAug 4, 2025
What to do if my Icom ID-52A does not turn ON?
- A
  Ashley ThompsonAug 4, 2025
  If your Icom Transceiver does not turn on, consider the following: * The battery may be exhausted. Charge the battery pack, or replace the batteries. * The connection of a battery pack (case) might be loose. Clean the battery terminals. * The battery polarity in the battery case could be reversed. Check the battery polarity in the case.
M
Matthew PooleAug 10, 2025
Why is the displayed frequency erroneous on my Icom ID-52A Transceiver?
- T
  Tyler JohnsonAug 10, 2025
  If the displayed frequency on your Icom Transceiver is incorrect, it may be due to: * A CPU malfunction, in which case you should reset the transceiver. * External factors causing a fault. Try removing and reattaching the battery pack/case.
H
Heather BerryAug 15, 2025
Why is the sensitivity too low on my Icom ID-52A Transceiver?
- W
  woodmatthewAug 15, 2025
  If the sensitivity of your Icom Transceiver is too low, and you can only hear strong signals, check the following: * If using an external antenna, the coaxial cable may not be connected or shorted. Check the coaxial cable connection or replace it with a new one. * The Attenuator function may be turned ON. Turn OFF the attenuator.
Y
ynelsonAug 21, 2025
What to do if no reply is received after a call on Icom Transceiver?
- J
  Joseph DavisAug 21, 2025
  If you do not receive a reply after making a call on your Icom Transceiver, it could be because: * The duplex function is set, meaning the receive and transmit frequencies are different. Set for simplex operation. * No station is in range or on the same frequency. Wait for a while, and try again.