Icom IP100H - Page 31

DGX-IP1000C/IP100H -V1.0
28
STEP 2: ACCESS POINT SETTINGS
Set your access point’s IP address to 192.168.0.50, and SSID to WAVEMASTER-0.
[RECOMMENDATION]
We recommend that you set the access point’s authentication as follows:
For example:
• Authentication: WPA-PSK·WPA2-PSK
• Encryption Type: TKIP·AES
• PSK: 5cf97dgh6
STEP 3: IP1000C SETTINGS
The setting steps are as follows.
STEP 3-1 The DHCP Server settings
STEP 3-2 Common settings
STEP 3-3 Area Call settings
STEP 3-4 The IP100H (TR 1) settings
STEP 3-5 The IP100H (TR 2) settings
STEP 3-6 The IP100FS settings
STEP 3-7 Group ID settings (If required)
STEP 3-8 Enter the destination ID
STEP 3-9 Select the message group number and enter the message
STEP 3-10 Select the message list
STEP 3-11 Use ID list and message setting
STEP 3-1 The DHCP Server settings
IMPORTANT! If you turn ON the Hide SSID function when using IEEE802.11a, IP100H may not connect
to the access point.
STEP 1 STEP 2 STEP 3 STEP 5 STEP 4 STEP 6
STEP 1 STEP 2 STEP 3 STEP 5 STEP 4 STEP 6
Select
Click
Click
Click