26
Assigning DAW mode (Mackie control/HUI)
with iMap
TM
Tip: You may also use the hardware to select DAW mode
instead of through iMap. Please refer to P.9 for instructions.
To begin DAW mode setup, connect your Platform M with iMap. Follow the
steps below:
1. Connect Platform M to your Mac/PC.
2. Launch iMap and click “Connect Device”.
Note: If your Platform M is not connected to your Mac/PC, the message “There
are no MIDI input devices” will appear. Please connect Platform M to your
Mac/PC with the provided USB cable.
iMap
TM
Platform M software panel
Diagram 7
To Next Page
Loading...
