9
LED① = Nuendo
LED② = Cubase
LED③ = Logic Pro
LED④ = Samplitude
LED⑤ = Ableton Live
LED⑥ = Pro Tools
LED⑦ = User define
LED⑧ = Reaper
LED①+② = Studio One
LED③+④ = Reason
LED⑤+⑥ = Bitwig
Esc
F1
F2
F3
F4
F5
F6
F7
F8
F9
F10
F11
F12
Prtsc
sysrq
pause
Break
Lns
Del
Home
Pgup
PgDN
End
$
~
`
！
1
··
2
3
4
5
6
7
78
9
0
）
）
*
—
-
+
=
#
￥
%
*
#
#
Q
W
E
R
T
Y
U
I
O
P
{
}
|
A
S
D
F
G
H
J
K
L
:
;
Z
X
C
V
B
N
M
<
>
?
Tab
CapsLook
Shift
Ctrl
Alt AltGr
Ctrl
Backspace
[
]
|
Enter
Shift
intel
3
2
1
4
Connect the Platform M+ to your Mac/PC via the USB port
Choose a USB port on your Mac/PC and insert the wide (at) end of the USB
cable. Connect the cable’s other end to the Platform M+. Your Mac/PC should
automatically “detect” the new hardware and notify you that it is ready to use.
1. Select the DAW at Platform M+.
Press << (channel 6’s “Sel” button)/>> (channel 7’s “Sel” button) to scroll through
the control-mode list, and then press the “DAW” (channel 8’s “Sel” button) button to
make the selection.
The control-mode name will display on the LCD while you are scrolling through the
list to make the selection if Platform D / Platform D2 (optional) is installed.
Otherwise, the 9 channel’s LED indicator lights located on the top will indicate the
DAW. The sequence is as follows:
Channel 1 LED: MCP (Nuendo / Cubase / Samplitude / Ableton Live / Reaper /
Studio One / Reason / Bitwig / Sonar / Audition / FL Studio / Digital Performer)
Channel 2 LED: Logic Pro
Channel 3 LED: HUI (Pro Tools)
Channel 4 LED: User dene
Tip: Platform M+ will memorise your last selected DAW mode and re-enter the
same mode a few seconds after it has been switched on. (i. e. DAW mode
selection is not needed if the last mode is being used. )
2
4
2. Setup your DAW
Activate the ICON Platform M+ controller in your DAW or MIDI software using “MIDI
Setup” or “MIDI Devices”.
For LogicPro, Cubase/Nuendo, Samplitude, Ableton Live, Reaper, Studio One, Reason,
Bitwig, Sonar, Audition, FL Studio, Digital Performer select Mackie Control.
For Pro Tools select HUI
(Tip: You may also refer to our website at www. iconproaudio. com, at each
controller (Platform M+) product page’s “Setup demo” section for different DAW
set up illustrations.
For DAW that not on our setup demo list, please refer to your software user
manual for the hardware setup. )
5
Getting Started
Connecting Your Platform M+ Controller
To Next Page
Loading...
Need help?
General
