What to do if ICON PRO-FORM 6.0 RT Treadmill power does not turn on?
First, ensure you've followed all surge suppressor and grounding instructions. Verify the power cord is correctly plugged in and the key is inserted into the console. Check the power switch located on the treadmill frame near the power cord. If the switch is off, wait five minutes, then reset it. If the issue continues, remove the key and unplug the power cord.
Why does my ICON PRO-FORM 6.0 RT power turn off during use?
The power may turn off during use due to a tripped power switch. If the switch has tripped, wait five minutes before pressing it back in. Also, ensure the power cord is securely plugged in; unplug it, wait five minutes, then plug it back in. Finally, try removing and reinserting the key from the console.
What to do if ICON PRO-FORM 6.0 RT Treadmill walking belt is off-center or slips?
If the walking belt is off-center, remove the key and unplug the power cord. If the belt shifted left, turn the left idler roller screw clockwise 1/2 turn; if it shifted right, turn it counterclockwise 1/2 turn. Be careful not to overtighten the belt. If the belt slips, remove the key and unplug the power cord. Turn both idler roller screws clockwise 1/4 turn.
How to fix ICON Treadmill walking belt slowing down when walked on?
If the walking belt is overtightened, remove the key and unplug the power cord. Turn both idler roller screws counterclockwise 1/4 of a turn. When properly tightened, you should be able to lift each edge of the walking belt 2 to 3 inches off the walking platform. Also, your treadmill features a walking belt coated with high-performance lubricant. Never apply silicone spray or other substances to the walking belt or the walking platform unless instructed by an authorized service representative.
What to do if ICON PRO-FORM 6.0 RT incline does not change correctly?
To recalibrate the incline system, hold down the Stop button and the Speed increase button, insert the key into the console, and then release the Stop button and the Speed increase button. Next, press the Stop button and then press the Incline increase or decrease button. The treadmill will automatically rise to the maximum incline level and then return to the minimum level.
How to turn off demo mode on ICON Treadmill?
The console may be in display demo mode. To turn off the demo mode, hold down the Stop button for a few seconds.
To Next Page
General