What to do if ICON Treadmill turns off during use?
If your ICON Treadmill shuts off during use, first check the power switch and reset it if it has tripped by waiting five minutes and then pressing the switch back in. Ensure the power cord is securely plugged in; if it is, unplug it, wait five minutes, and plug it back in. You can also try removing and reinserting the key from the console. If the treadmill still won’t run, no answer.
How to fix ICON Treadmill walking belt that is off-center or slips?
If the walking belt on your ICON Treadmill is off-center or slips, first remove the key and unplug the power cord. For an off-center belt, if it has shifted to the left, turn the left idler roller screw clockwise 1/2 turn using the hex key. If it has shifted to the right, turn the left idler roller screw counterclockwise 1/2 turn. If the belt slips, turn both idler roller screws clockwise 1/4 turn with the hex key.
Why ICON Treadmill walking belt slows down when walked on?
If the walking belt on your ICON Treadmill slows down when you walk on it, it might be overtightened. Remove the key and unplug the power cord. Use the hex key to turn both idler roller screws counterclockwise 1/4 of a turn. If you suspect that the walking belt needs more lubricant, or if the walking belt still slows when walked on, no answer.
How to turn off demo mode on ICON Treadmill?
If the console displays on your ICON Treadmill stay lit after removing the key, the treadmill may be in display demo mode, which is designed for store displays. To disable this mode, press and hold the Stop button for a few seconds. If the displays are still lit, no answer.
What to do if ICON Treadmill incline does not change correctly?
If the incline on your ICON Treadmill isn't changing correctly, hold down the Stop button and the Speed increase button, insert the key into the console, and then release the Stop button and the Speed increase button. Next, press the Stop button, and then press the Incline increase or decrease button. If the incline system does not begin calibrating, press the Stop button again, and then press the Incline increase or decrease button again.
Consult a doctor before starting any exercise program, especially if over 35 or with health issues.
Use for home, indoors, on level surface; for persons 325 lbs or less, not for reduced capabilities, one person.
Use a UL-listed surge suppressor; keep cords away from heat.
Test and use the emergency stop clip for safety during operation.
Annual checks, unlimited in-home repairs, covers defects and wear, up to 5 years.
Unlimited in-home repairs, covers defects and wear, up to 3 years coverage.
Familiarize yourself with the labeled parts of the treadmill shown in the diagram.
Register your product online at iconservice.com to activate warranty and save time.
Requires two persons, cleared area, and specific tools like hex keys and screwdriver.
Connect the power cord to a surge suppressor and a grounded outlet for safe operation.
Adjust incline to zero, remove key, unplug, then lift frame to vertical position.
Fold treadmill, ensure latch is locked, use one foot on wheel, pull handrail to roll.
Carefully lower the frame, ensuring the latch pin clears the foot rail.
Wipe exterior parts with a damp cloth and mild soap; avoid spraying liquids directly.
Address power not turning on or turning off during use by checking connections and switches.
Resolve console lights remaining on by disabling demo mode or checking information mode.
Recalibrate the incline system by holding Stop and Speed buttons, then pressing Incline buttons.
Troubleshoot belt slowing or slipping by adjusting idler roller screws and checking tightness.
Use heart rate zones for fat burning and aerobic exercise based on age.
Follow guidelines for warming up, training zone exercise, and cooling down.
Aim for three workouts per week, with rest days, and potentially increase to five.
To Next Page
General