31
Assigning DAW Mode (Mackie control/HUI)
Using iMap
TM
Tip: You may also use the hardware to select DAW instead of through iMap.
Please refer to P.13-14 for instructions.
To begin DAW mode setup, connect your QconPro X with iMap. Follow the
steps below:
1. Connect QconPro X to your Mac/PC
2. Launch iMap and click “Connect Device”
Note: If your QconPro X is not connected to your Mac/PC, the message “There
are no MIDI input devices” will appear. Please connect QconPro X to your
Mac/PC with the provided USB cable.
iMap
TM
QconPro X software panel
Diagram 7
To Next Page
Loading...
