33
Assigning MIDI Messages in User-Dened
Mode Using iMap
TM
iMap
TM
QconPro X software panel
To begin the “User denes” mode setup, let make the connection of your
QconPro X with iMap. Please follow the below steps:
1. Connect QconPro X to your Mac/PC
2. Launch iMap and click “Connect Device”
Note: If your QconPro X is not connected to your Mac/PC, the message “There
are no MIDI input devices” will appear. Please connect QconPro X to your
Mac/PC with the provided USB cable.
Diagram 8
To Next Page
Loading...
Need help?
General
