ICON STAGE - Page 20

ICON STAGE USER MANUAL
19
3) Press< ENTER>，the display will show “Total run Time”.
4) The display will show “XXXX” (Hours).
5) Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.5.5 Last Run Time
With this function，you can display last the running time of the device. The display shows “XXXX”，
“XXXX” stands for the number of hours.
1) Tap <MODE/ESC>button，access the main menu，Tap the <Up/Down>button until “Info”is
displayed. Press <ENTER>，the display will show “Info”.
2) Press <Up/Down>，the display will show “Last Run Time”.
3) Press< ENTER>，the display will show “Last Run Time”.
4) The display will show “XXXX” (Hours).
5) Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.5.6 Temperature
Head Temperature
1) Tap <MODE/ESC>button，access the main menu，Tap the <Up/Down>button until “Info” is
displayed. Press <ENTER>，the display will show“Info”.Tap the <Up/Down>button
until “Temperature” is displayed. Press <ENTER>，the display will show “Temperature”.
2) Press <Up/Down>，the display will show “Head Temperature”.
3) Press< ENTER>，the display will show “Head Temperature”.
4) The display will show“XXX℃/℃”.
5) Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.5.7 Service Setting
Password——The Password for this function is “50”.
Clr Err Info
With this function you can clean the error information.
1) Tap <MODE/ESC>button，access the main menu，Tap the <Up/Down>button until “Info” is
displayed. Press <ENTER>，the display will show “Info”. Tap the <Up/Down>button until
“Service Setting” is displayed. Press <ENTER>，the display will show “Service Setting”.
2) Press <Up/Down>，the display will show “Clr Err Info”.
3) Press< ENTER>，the display will show“Clr Err Info”.
4) The display show “OFF”，Press <Up/Down>，the display will show “ON”.
5) Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.5.8 Fan Speed
With this function，you can set the speed of the running fans. The selection have Head2UFan1，
Head2UFan2，…….
1) Tap <MODE/ESC>button，access the main menu，Tap the <Up/Down>button until “Info” is
displayed. Press <ENTER>，the display will show “Info”.
2) Press <Up/Down>，the display will show “Fan Mode”.
3) Press< ENTER>，the display will show “Fan Mode”.
4) The display will show “Head2UFan1= xxxx RPM”，“Head2UFan2= xxxx RPM”，“……”.
5) Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.5.9 Error Info
With this function，you can display the error informatin. The selection have Error Record 1，Error