ICON STAGE - 9.1 Address Configuration; 9.2 Device Configuration Options

ICON STAGE USER MANUAL
15
9.1 Address
9.1.1. Address
With this function，you can adjust the desired DMX-address via the Control Board.
1) Access the main menu.
1) Tap the <Up/Down> button until “Address” is displayed.
2) Press <ENTER>，the display will show “Address”.
3) Tap the <Up/Down>button，the display will show“A001~AXXX”.
4) Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.2 Config
9.2.1 Mode
With this function，you can define the device as slave.
1) Tap <MODE/ESC>button，access the main menu，Tap the <Up/Down>button until “Config” is
displayed. Press <ENTER>，the display will show “Config”.
2) Tap the <Up/Down>button until “Mode” is displayed.
3) Press <ENTER>，the display will show“Mode”.
4) The display show“Extended Mode”，Press <Up/Down>，the display will show “Standard
Mode ” .
5) Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.2.2 Select Signal
With this function，you can define the device as slave.
1) Tap <MODE/ESC>button，access the main menu，Tap the <Up/Down>button until “Config” is
displayed. Press <ENTER>，the display will show “Config”.
2) Tap the <Up/Down>button until “Select Signal” is displayed.
3) Press <ENTER>，the display will show “Select Signal”.
4) The display show “DMX Only”，Press <Up/Down>，the display will show “Art-Net On IP2”，
“Art-Net On IP10”，“sACN”.
5) Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.2.3 Set Universe
1) Tap <MODE/ESC>button，access the main menu，Tap the <Up/Down>button until “Config” is
displayed. Press <ENTER>，the display will show “Config”.
2) Press <Up/Down>，the display will show“Set Universe”.
3) Press< ENTER>，the display will show“Set Universe”.
4) The display show“0000~32767”.
5) Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.2.4 Pan and Tilt
Tilt Reverse
With this function you can reverse the Tilt-movement.
1) Tap <MODE/ESC>button，access the main menu，Tap the <Up/Down>button until “Config” is
displayed. Press <ENTER>，the display will show “Config”. Tap the <Up/Down>button until
the display will show “Pan and Tilt”. Press <ENTER>，the display will show “Pan and Tilt”.
2) Press <Up/Down>，the display will show “Tilt Reverse”.
3) Press< ENTER>，the display will show“Tilt Reverse”.
4) The display show “OFF”，Press <Up/Down>，the display will show “ON”.