ICON STAGE - Info

ICON STAGE USER MANUAL
18
2) Tap the <Up/Down>button until“DMX Info”is displayed.
3) Press <ENTER>，the display will show“DMX Info”.
4) The display show“DMX Update Rate =XXXX p/s”.
5) Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.4.3 Comm Loss
1) Tap<MODE/ESC>button ， access the main menu ， Tap the <Up/Down>button until
“Communication” is displayed. Press <ENTER>，the display will show “Communication”.
2) Tap the <Up/Down>button until “Comm Loss” is displayed.
3) Press <ENTER>，the display will show “Comm Loss”.
4) The display show “Fade out 30 seconds”，Press <Up/Down>，the display will show “No Fade
on Loss”，“Fade out 30 seconds”，“Fade out 60 seconds”.
5) Press ENTER to confirm or press <MODE/ESC> to return to the main menu.
9.5 Info
9.5.1 Software Version
With this function，you can display the software version of the device.
1) Tap <MODE/ESC>button，access the main menu，Tap the <Up/Down>button until“Info”is
displayed. Press <ENTER>，the display will show “Info”.
2) Press <Up/Down>，the display will show “Software version”.
3) Press< ENTER>，the display will show “Software version”.
4) The display show“X.X.X……”.
5) Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.5.2 ARTNET IP
1) Tap <MODE/ESC>button，access the main menu，Tap the <Up/Down>button until “Info” is
displayed. Press <ENTER>，the display will show“Info”.
2) Press <Up/Down>，the display will show “ARTNET IP”.
3) Press< ENTER>，the display will show “ARTNET IP”.
4) The display will show“XXX. XXX. XXX. XXX”.
5) Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.5.3 Cross load Software
1) Tap <MODE/ESC>button，access the main menu，Tap the <Up/Down>button until“Info”is
displayed. Press <ENTER>，the display will show “Info”.
2) Press <Up/Down>，the display will show “Cross load Software”.
3) Press< ENTER>，the display will show “Cross load Software”.
4) The display show “OFF”，Press <Up/Down>，the display will show “ON”. If you want to need
the “ON”，the need password is 50 .
5) Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.5.4 Total Run Time
With this function，you can display the running time of the device. The display shows “XXXX”，
“XXXX”stands for the number of hours.
1) Tap <MODE/ESC>button，access the main menu，Tap the <Up/Down>button until “Info” is
displayed. Press <ENTER>，the display will show “Info”.
2) Press <Up/Down>，the display will show “Total run Time”.