ICP SAVANNAH XL User Manual

MAINTENANCE MANUAL
SAVANNAH VG AND
SAVANNAH XL
Doc. No.:
MM-SVNH-VG&XL-EN
Revision:
05
Rev. Date:
28/12/2022
Proj. Ref.:
Savannah Model 51
A/C: Savannah VG&XL
Applies to Generic Serial Number: yy-mm-51-xxx
Page:
15/24
OC FMM00
NOTE
The maximum allowed play in the flight controls system hinges is 0.6
mm; when a greater play is found, please contact the manufacturer
NOTE
Before replacing loose or corroded rivet, please contact the manufacturer
NOTE
If a skin crack is found, before next fly please contact the manufacturer
NOTE
In the event of a hit on the wing leading edge, it has to be understood
they don’t reduce the wing structural resistance until they become more
than 15 mm long over each 1 m wing span; they could slightly affect the
in-flight aircraft’s trimming; periodically check for a crack that could arise
2.4. 200 hours / 18 months
CAUTION
To properly maintain the engine, it’s strongly recommended to follow the
engine manufacturer instructions and all Rotax service information
NOTE
The 200 hours/18 months inspection requires that a 100 hours inspection
(25 hours plus the 50 hours adding checks, plus the 100 hours adding
checks) is carried out plus the checks below stated
N.
Description
1
Check the fuel pipes, replace the fuel filter and the gascolator valve gasket
2
Drain and refill the coolant fluid in the cooling system
3
Replace the spark plugs
4
Check carefully the silencer
5
Remove, clean and reinstall the oil reservoir
6
Completely replace the liquid of the braking system. To bleed the brakes, use the
purposely-allocated valve on the brake cylinders

ICP SAVANNAH XL Specifications

General

Brand	ICP
Model	SAVANNAH XL
Category	Aircrafts
Language	English