MAINTENANCE MANUAL
SAVANNAH VG AND
SAVANNAH XL
Applies to Generic Serial Number: yy-mm-51-xxx
OC FMM00
2. Inspection and maintenance schedule
Daily/Pre-flight inspection
before the first flight each day
50 hours/ 6 months inspection (whichever
comes first)
every 50 hours flight time/6 months calendar
time (whichever comes first)
100 hours/12 months inspection (whichever
comes first)
every 100 hours flight time/12 months calendar
time (whichever comes first)
200 hours/18 months inspection (whichever
comes first)
every 200 hours flight time/18 months calendar
time (whichever comes first)
every 600 hours flight time
1000 hours flight time/72 months
every 1000 hours flight time/72 months calendar
time
1500 hours inspection (Engine overhaul)
every 1.500 hours flight time
Below are indicated the exact meaning of all the terms used in the inspection reports in order to
avoid any possible misunderstanding.
Inspection to be performed without using any instrument or testing device,
by expert and trained eye only.
Inspection to be performed by supplying the component to be inspected
with the proper energy, in order to check its correct operativity, without
removing the component from the aircraft.
It’s a verification of a component, without disembarking it from the aircraft,
to be performed by using a tester or other suitable instrumentation, to
check its proper operation.
It’s a verification, typically to be performed by the pilot, without removing
anything from the aircraft, to determine whether there is a correct cause-
effect relation produced by engaging the device to be checked.
It’s a verification of a component, disembarked from the aircraft, to be
performed by connecting it to a testing bench or other laboratory suitable
instrumentation, to check its proper operation and measure some
significant parameters values.
To Next Page
Loading...
Need help?
General
