➢ When inserting the USB driver, make sure the direction you selected is correct. Never insert
violently to avoid damaging the USB driver or the unit. If it doesn’t work, please make sure if the
direction is correct.
Power on/off the Device
A. Press and hold the button on the right cabinet approximately 5 seconds to power on the
unit. Touch and slide the key bar shown on the screen to from below to above unlock
B. In power on mode, press the button to turn off the screen for saving battery power. Press
again to turn it on.
C. To power off the device, press and hold the button until the “Power off” window pop up,
touch the “Power off” and show ” shut down” message, the device will to power off
Reset:
If the device becomes abnormal, halts, freezes. Press the RESET Button in the reset hole on the
rear of device (see figure as below) with a small screwdriver (not included) to reset the device.
To Next Page
Loading...
