25
© 2014 ICS, Blount International Inc. Specications are subject to change
without notice. REV061914 F/N 545067
WARM ENGINE STARTING PROCEDURE
1. Use the same procedure as starting a cold engine, but pull choke lever
out, and then push back in to set the throttle lock. If choke is used on
a warm engine, the carburetor will flood with gas.
2. If the engine does not start in 3 hard, fast pulls with the throttle locked,
fully squeeze and hold the trigger while pulling the starter cord 3 more
times.
Note: To hold the trigger fully open it may be necessary to insert right
foot into rear handle opening
and twist.
STOPPING THE SAW
• To turn the engine off, push stop switch to the "STOP" position. Close
water valve.
COLD ENGINE STARTING PROCEDURE, CONT.
7. With opposite hand, slowly pull starter handle until the
starter pawls engage.
8. Pull the starter cord (hard, fast, short pulls) until engine initially fires
or "pops". Could be as many as 10-15 pulls.
9. Push the choke lever in.
10. Pull the starter cord until engine starts - should be 1 to 2 pulls.
11. Release the throttle lock by momentarily squeezing on the throttle
trigger.
12. When the engine starts, allow the engine to idle briefly.
Squeeze the throttle trigger several times to help
warm up the engine.
13. Open the water valve completely.
OPERATION
To Next Page
Loading...
