28
© 2014 ICS, Blount International Inc. Specications are subject to change
without notice. REV061914 F/N 545067
CUTTING WITH THE 695GC
To start a cut, hold trigger on full throttle and slowly plunge the nose of
the bar straight into the wall. Lengthen the cut and engage the point of the
WallWalker
®
. Use the WallWalker as a pivot point and pull up on the rear
handle to rotate the bar into the cut.
CUTTING TIPS
• Always operate the concrete chain saw at full throttle. If too much force
is applied, the saw will lug or stall. The chain will not have enough
speed to cut effectively. If too little feed force is applied, the diamonds
will skid and glaze over.
• For straighter cuts use the “Step Cut” method. First score the entire cut
line with the nose of the guidebar approximately 1/2 in (12 mm) to 1 in
(25 mm) deep. Next, deepen the cut by about 2 in (50 mm). This groove
will help guide the guidebar for a straight cut. Then plunge all the way
through and complete the cut using the WallWalker.
• Plunge cut instead of starting at the top surface of the wall. This will
reduce chatter, extend diamond life, create a straighter cut and more
quickly enable the use of the WallWalker.
OPERATION
To Next Page
Loading...
