33
© 2014 ICS, Blount International Inc. Specications are subject to change
without notice. REV061914 F/N 545067
STARTER HOUSING ASSEMBLY
It is common for concrete slurry to get inside the starter housing
assembly during cutting. This can cause the starter pawls to stick and
not engage when the rope is pulled.
IMPORTANT
• After each usage, thoroughly flush the starter housing assembly
with water.
• Oil the starter pawls by spraying lightweight oil into the starter
housing through the vents.
• Check the starter cord
for fraying, replace if
necessary.
MAINTENANCE
To Next Page
Loading...
