ICS 695GC - Guidebar and Chain Assembly

5
© 2014 ICS, Blount International Inc. Specications are subject to change
without notice. REV061914 F/N 545067
• Loosensidecovernutandremovesidecover.
• Placebarontostudandengagealignment
block.
• Mountthediamondchainontheguidebar
startingatthedrivesprocketandcontinue
overtheguidebarnose.
 NOTE:FORCE4requiresrimtobepulled
outwardforchaininstallation.
ASSEMBLING THE SAW
1
2
3
WARNING
Neverstartthesawwithouttheguidebar,
diamondchainandsidecoverproperlyinstalled.
Failuretodosomayresultinseriousinjury.
QUICK START GUIDE