ICS 695GC - Page 6

6
© 2014 ICS, Blount International Inc. Specications are subject to change
without notice. REV061914 F/N 545067
• Installthesidecoverandensurechain
adjustmentpinengagesholeinbar.
• Donotfullytightensidecovernutuntil
afterchainisproperlytensioned.
• Makesureallthedrivelinksareinside
theguidebargroovethenliftthebar
noseandtensionthechainbyturningthe
screwclockwise.
• Beforecutting,checkforpropertension
bypullingthechainaroundthebarby
hand.Ifyoucannoteasilypullbyhand,
thechainistootightandneedstobe
loosenedslightly.
 CAUTION:Beawarethatguidebarrails
maydevelopsharpedgesovertimeso
alwayspullthediamondchainbythe
diamondsegments.
4
5
6
QUICK START GUIDE
ASSEMBLING THE SAW
(continued)