Construction Cards
When a Protege wireless lock is in factory default state, it can only be unlocked using a construction card provided
by ICT. Construction cards are also used to initialize locks and connect them to the access control system.
Construction cards are not included with the locks and must be ordered separately. Any ICT construction card will
work with any Protege wireless lock.
Card Code
ICT Construction Card WL-CONST
Wireless Access Points
Wireless access points are required for online operation. One access point supports up to 8 wireless locks, allowing
up to 128 online locks to be connected per online hub.
Access Point Code
Wireless Access Point WL-AP
Replacement Parts
In addition to the components included in the initial installation, the following individual components may be
ordered for replacement.
The required finish will need to be specified when ordering replacement parts.
Mortise Lock Strike Plate Replacement Code
Mortise Strike Plate SPM
Mortise Lock Faceplate Replacement Code
Mortise Dress Plate (no Deadbolt) DPM
Mortise Dress Plate (with Deadbolt) DPM-DB
Key Cylinder
The mortise lock mechanism contains space for an optional key cylinder. A suitable 1 ⅛" mortise key cylinder may
be obtained from a third-party supplier.
Protege Rear Mount Mortise Wireless Lock | Installation Manual 9
To Next Page
