Need help?Do you have a question about the ICT Protege and is the answer not in the manual?
General| Reader Technology | Proximity |
|---|---|
| Communication | RS-485 |
| Tamper Protection | Yes |
| Operating Humidity | 0% to 95% (non-condensing) |
| Card Technology | 125kHz Proximity |
| Supported Cards | HID Prox |
| Output Format | Wiegand |
| Weight | 100g |
Describes the ICT card reader as an advanced RFID device for security and access control.
Lists the current features of ICT card readers, including multi-card support and connectivity options.
Explains how ICT card readers are programmed using TLV settings within a time window after powering up.
Details the configuration steps within LoadIT software for updating card reader firmware via RS-485.
Outlines the steps to program a card reader using the Protege Config App and Bluetooth.
Lists requirements for using the Config App and for the card reader itself, including firmware version and capability.
Instructions for downloading the Protege Config App from the Google Play Store.
Instructions for downloading the Protege Config App from the App Store.
Details on logging into the Protege Config App using existing or new account credentials.
Explains how to navigate the Config App and lists available pages like Reader Configuration and Account Settings.
Describes creating and managing configuration profiles (configs) using TLV settings in the Config App.
Introduces TLV settings available in the Protege Config App, with a warning about potential reader issues.
Demonstrates creating a config to enable OSDP communication protocol for the card reader.
Shows how to create a config to set the reader's baud rate for OSDP communication.
Explains creating a config to put the reader into OSDP installation mode for secure channel session initiation.
Details programming a reader's address for RS-485 or OSDP protocols, including entry/exit reader configuration.
Demonstrates enabling dual LED mode for the card reader, which requires specific wiring.
Shows how to create a config to change LED colors for functions like door locked/unlocked status.
Explains customizing reader modulation and gain settings for specific frequency formats like DESFire EV2 tags.
Demonstrates configuring the reader to output data in Wiegand format.
Shows how to create a config to put the reader into firmware update mode (boot mode).
Explains creating a config to reset the reader to its factory default configuration.
Lists requirements for using a MIFARE config card for reader programming.
Covers common reader programming settings like LED Mode, Backlight, and Output Mode.
Step-by-step guide on programming a reader using a config card.
Lists requirements for using a 125kHz programming card to program readers.
Describes how to enter programming mode using a 125kHz card, including timeout periods.
A programming example showing how to set the interface to output 26 Bit Wiegand.
To Next Page
