ICT Protege - Table of Contents

Contents
Introduction 5
About This Module 5
Programming ICT Card Readers 5
Updating Card Reader Firmware 6
Protege Config App 7
Programming Summary 7
Prerequisites 7
Installing the Config App 8
Logging In 8
Config App Navigation and Settings 9
Reader Configuration 10
Config Management 10
TLV Settings 10
Programming a Card Reader 21
Failed Programming 21
Config Programming Examples 23
Config Example: Enable OSDP 23
Config Example: OSDP Baud Rate 23
Config Example: OSDP Install Mode 24
Config Example: Reader Address 24
Config Example: Enable DualLEDMode 25
Config Example: LED Colors 25
Config Example: ISO14443 Gain for EV2 Tags 26
Config Example: Set Wiegand Output Mode 26
Config Example: Firmware Update Mode 27
Config Example: Factory Default 27
Config Example: Custom Credential 28
MIFARE Config Card 30
Prerequisites 30
Config Card Settings 30
Basic Settings 30
Advanced Settings 31
Programming a Card Reader 31
125kHz Programming Card 32
ICT Card Reader | Configuration Guide 3