ICT Protege - Creating a Card Linkage

Create a Card Linkage
Finally, we can create our card linkage to tie everything together, using the Card Linkages TLV (see page15).
For our scenario, we need to define the card linkage parameters as follows:
1. Tap Add TLV and select Card Linkages.
2. Set the following card linkage configuration:
- Linkage Slot: 6
- Flags: AES256 Decryption
- Keyslot: 2 (this is the keyslot where we stored our encryption key)
- Access Credential Slot: 7 (this is the slot where we stored our DESFire credential configuration)
- Format Slot: 6 (this is the slot where we stored our card format string)
Save and Apply
With all the components completed you can now Save the completed config. The new credential programming
can be applied to the reader within 2 minutes of startup.
ICT Card Reader | Configuration Guide 29