EasyManua.ls Logo

ID Tech MINIMAG - Change to Default Settings; Review Settings

ID Tech MINIMAG
37 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
b3=2 for 10 ms intercharacter delay
b3=3 for 20 ms intercharacter delay
b3=4 for 25 ms intercharacter delay
b3=5 for 50 ms intercharacter delay
EXAMPLE
To set the terminal type to PC-AT, the beep to high, and the interchar
-
acter delay to 5 milliseconds, enter:
/e/d/fa<space>021<ENTER>
Note: Two beeps will be heard if entered numbers are outside the al
-
lowable range.
Change To Default Settings
This command, /e/d/fn, returns all settings for all groups to their de-
fault values. Data Editing will be turned off, and the formulas will be
retained.
Syntax: /e/d/fn<ENTER>
Review Settings
This command, /e/d/fo, activates the review settings command. This
will send the resident settings for the general group to the host com-
puter, allowing you to review them. The firmware version number is
also shown.
Syntax: /e/d/fo<ENTER>

Other manuals for ID Tech MINIMAG

Related product manuals