ID Tech MINIMAG User Manual

15
Data Editing Setup Commands
The following commands are used to set the operating parameters of
the data editing feature.
Data Editing On/Off, Matched/Unmatched
Syntax: /e/d/fe<space> b1b2 <ENTER>
where:
b1 = 1 Data Editing On
b1 = 0 Data Editing Off
b2 = 1 if no formula matches card data, send out whole card data
b2 = 0 if no formula matches card data, do not send anything
Data Editing Added Field
An output field is created containing the character string. Up to six
fields can be defined. The maximum characters of each field is six.
Syntax: /e/d/fr<space>f1<space>f2<space>f3<space>f4
<space>f5<space>f6<ENTER>
where:
Maximum of Added field is six;
Maximum characters of each field is six;
Separator between each field in command is space;
Command: /e/d/fr<space>Idt<space>;<space>\cr<space>
\f1<space>\htITS<ENTER>

ID Tech MINIMAG Specifications

General

Interface	TTL
Scan speed (max)	76.2 mm/sec
Operating voltage	5 V
Power consumption	4 mA
LED indicators	Yes
Storage temperature (T-T)	-30 - 70 °C
Operating temperature (T-T)	0 - 55 °C
Cable length	1.8 m

Weight and Dimensions

Weight	130 g
Dimensions (WxDxH)	34 x 90 x 28 mm