To Next PageTo Next PageWhat to do if my Ideal Heating Boiler has no hot water and no central heating?
First, ensure the mains power is on and 'Mode ON' is displayed at the bottom of the screen. If it's not, press the button to activate it. If the problem continues, contact a Gas Safe registered engineer.
How to fix no central heating on my Ideal Heating LOGIC SYSTEM 2 S30?
First, check that the mains power is turned on and that 'Mode ON' is displayed at the bottom of the screen. If it's not, press the button to activate it. Also, ensure that the programmable room stat or timer are calling for heat. Finally, verify the time settings on the programmer and adjust them if necessary.
Explains boiler controls and steps to start the unit.
Describes boiler status display and common fault messages.
Details Winter/Summer modes and setting water temperatures.
Tips for efficient operation and frost protection mechanism.
Instructions for unblocking a frozen condensate pipe.
Procedure for identifying and re-pressurising the system.
Actions to take in case of suspected gas leak.
Guidance on cleaning the boiler and required annual servicing.
How to restart the boiler using the restart button.
Flowcharts for diagnosing no hot water or no central heating issues.
Explains various status codes shown on the boiler display.
General| Type | System Boiler |
|---|---|
| Output | 30 kW |
| Dimensions (H x W x D) | 700 x 395 x 278 mm |
| Fuel Type | Natural Gas |
| Warranty | 2 Years |
| Mounting | Wall Mounted |
| CH Output (kW) | 30 kW |
| ErP Rating | A |
| Central Heating Flow Temperature Range | 30 - 80 °C |
