13
Proof of Performance
12
www.idealnetworks.net
Wi-Fi Settings
To connect LanTEK IV over Wi-Fi, tap Settings
Select “Wi-Fi” - then activate it using the switch at the top right
(green when active)
Select a network and enter the password if required
Wi-Fi is then connected if the
wave logo at the top right is
not crossed out
Make sure that the signal strength is greater than 50%.
Once connected, tap on the network name to view Wi-Fi details including
the security settings, IP address and MAC address.
On a site without a Wi-Fi network, use internet sharing with a mobile phone
that will be on a conventional mobile network.
Once connected, tests can be uploaded/download to AnyWARE Cloud using
“SYNC” from the home screen.
To Next Page
Loading...
