IDEAL Networks LanTEK IV - Standard Mode Test Operation Guide

16
www.idealnetworks.net
Standard User Interface Operation
Testing with Standard mode requires setting four parameters before a test can
be started.
All parameters can be set from the Home screen and each Autotest will be run
with the same parameters as the previous test. The last character of the test
name is incremented by one digit (either letter or number).
Previous Test - Name, type and result of
the test that was previously performed.
Touch the test name to open the results
page.
Next Test - Name of the next test to be
run. The last character increments with
each test. The test name can be changed
by touching the name.
Touch Test or press the Autotest key to
perform a test.
Settings
Job - Name of the folder where the next
test will be stored.
Touch the “search” icon to create or select
a dierent job.
Test standard - Summary of the test limit
and cable type that will be used for the
next test. Touch the box to change the
test standard settings.
Operator name - Name of user that is
stored with each test.
Touch the user icon to change the
operator name or add a new one.