IDEAL Networks NaviTEK NT Pro - Cable Tests Overview; Wiremap Setup and Termination Types; Cable Fault Testing (No Termination); Cable Fault Testing (Active Remote Termination)

NaviTEK NT 151844 Iss 4
User Guide Page 28
Cable Tests
Wiremap
Setup
Cable Type – 2 Pair
- 4 Pair 568A
- 4 Pair 568B
Shield - UTP
- STP
- UTP/STP
NVP – Fixed 72%
- Custom 59% - 89%
Termination Type
None - Open
Active Remote - #1 - #12
Tests (No Termination)
Faults – Open circuit by pair
- Short circuit by pin
Length of pair – Metres / Feet (Set in System Setup)
- Range 3-100m / 10-330ft
Tests (Active Remote Termination)
I/D – Remote #
Indications on Remote – Voltage Warning (>±10volts on any pins)
- Pass/Fail
Faults – Open circuit by pin
- Short circuit by pin
- Crossed pairs
- Split pairs
- Bridged shorts
- Remote shorts
Length of pair – Metres / Feet (Set in System Setup)
- Range 3-100m / 10-330ft
Tone Generator
Setup
No of Tones – 3
Wire I/D – Tone applied to one of 8 pins relative to the other 7
- Tone applied across one of 4 pairs
Test
Audible tone detected using compatible tone probe