Page 1
Introduction
Warning
To avoid shock or injury, do not perform the verification
tests or calibration procedures described in this manual
unless you are qualified to do so.
The information provided in this document is for the use
of qualified personnel only.
Caution
The 61-760 series contains parts that can be damaged by static
discharge. Follow the standard practices for handling static sensitive
devices.
For additional information about IDEAL INDUSTRIES, INC. and its products,
and services, visit IDEAL INDUSTRIES, INC. web site at:
www.idealindustries.com
Precautions and Safety Information
Use the meter only as described in the Users Manual. If you do not
do so, the protection provided by the meter may be impaired.
Read the “Safety Information” page before servicing this product.
In this manual, a Warning identifies conditions and actions that
pose hazard (s) to the user; a Caution identifies conditions and
actions that may damage the meter or the test instruments.
The Symbols
The symbols used on the meter and in this manual are explained
in Table A.
Table A Symbols
Symbol Description Symbol Description
Battery
HI-V
High Voltage Indicator
>30 V indicator is on
Cautionary or important
information in manual
Continuity indicator
Danger- Risk of electrical
shock
Double Insulation- Protection
Class II
CAT III
IEC Over-voltage Category III
CAT IV
IEC Over-voltage Category IV
TightSight™ Display Notes:
Only AC/DC amps units of measure are displayed in the TightSight™ display since primary use is
for viewing current measurements in tight locations. The display will show numerical values
only for other functions. The main display is to be used to view units of measure for all other
functions.
Form number TM61764-6-8 Rev 5 November 2007
To Next Page
Loading...
Need help?
General
