TROUBLESHOOTING.
POINTS FOR THE
BOILER USER
Note. In line with our current warranty
policy we would ask that you check
through the following guide to identify any
problems external to the boiler prior to
requesting a service engineer visit. Should
the problem be found to be other than
with the appliance we reserve the right to
levy a charge for the visit, or for any pre-
arranged visit where access is not gained
by the engineer.
NO HOT WATER
Check the mains switch (fused
spur) is turned on and ensure mode
control knob (B) (Control Panels: P.39)
is in the ON position
Check the programmer is in an “ON”
position and the cylinder
thermostat is turned up
Does the boiler operate and
provide hot water?
Check the time settings on the
programmer are as you require
and adjust if necessary
See boiler “Operation Modes” and
“Fault Codes” section. If “0” is
displayed then contact a Gas Safe
Registered Engineer or in IE a
Registered Gas Installer (RGII)
NO
YES
26
To Next Page
Loading...
Need help?
General