To Next PageTo Next Page
Need help?Do you have a question about the IDEAL EVOMAX 2 30 and is the answer not in the manual?
Gas Safety regulations and qualified engineer requirements for installation and maintenance.
Details power requirements (voltage, fuse) and connection methods for the appliance.
Critical operational do's and don'ts, including casing fitment, storage, ventilation, and unattended operation.
Specifies required spatial clearances around the boiler for safe installation and servicing.
Overview of the boiler control panel, display, LEDs, and function buttons with their operations.
How to use the rotary knob for navigation/adjustment and the function of the LCD screen.
Steps to set operating mode and demand for lighting a stand-alone or master boiler.
Refers to the installation manual for lighting a slave boiler in a cascade system.
Details status screens for various boiler configurations like master, slave, and 0-10V control.
Shows status displays for heating and DHW circuits, including set points and temperatures.
Allows individual setting of operating modes for each heating circuit.
Enables setting room temperatures for different periods for each heating circuit.
Details mains voltage, demand inputs, volts-free contacts, and PELV connections.
Lists optional sensor connections for cascade control, temperature readings, and heating curves.
How faults are indicated on the display and how to scroll through fault details.
Procedure for resetting faults after rectification, including handling multiple faults.
Instructions for shutting down for short/long periods and relighting after draining.
Details the boiler's frost protection capabilities and overheat detection/reset procedures.
Information on the condensate trap system and steps to address a frozen condensate pipe.
General